16Ft( 5M) White door edge trim Installation Steps: *Place the door trim under the sun for about 3-5 minutes (This step make the trim more flexible).
*Clean the door edge to remove any oil, wax & dust. Make sure the door is dry before continuing.
*Uncover the tape from the tip of the lining (Ensure the tape is install INSIDE the door) and peel the red strip off the tape by approximately 2 inches.
*Start from the top, insert the lining onto your door edge until the lining is fully seated.
*Press the lining with your thumb along the door edge until it is fully seated, then pull the red strip off.
*Repeat step 4 until all edges are protected.
*Use scissors to cut away unused lining for other door edges.
*Let the lining dry up by itself and do not get wet for at least 12 hours.
16Ft( 5M) Rubber Seal Protector Attentions : Our Door Edge Protected Lining works best for door edge thickness up to 2mm ( .078″). Attention to truck/van/jeep owners, please ensure your door edge thickness prior to purchase.If you’re not sure about comparability / fitment, please leave a message to us, we will answer your question through the customer service in time.
Make sure the position of the door edge guard is correct. The door guard will slowly bend into the proper position as you apply taps. Once in place, do not remove, reposition, or reinstall the door edge guard or it will not hold securely.
16Ft( 5M) rubber edge Package List: 1*white car door protector
- White car door edge guards: (No Glue Required)High quality TPO rubber material, heat resistance, abrasion resistance, anti-aging, waterproof & UV resistance.
- White car door protector: 3 colors (White, Black & Red) to select to match your vehicle color, Vehicle door edge guard protect each door edge and help maintain the vehicles condition by preventing door dings, dents (when open the door), chipping paint and rust.Protect Your Car Vehicle paint
- Door guard car :Thin/Slim design yet it efficiently protects your door. “ATTENTION! – NOT SUITABLE FOR DOOR THICKNESS MORE THAN 2mm ( .078 INCH)”. ADHESIVE: Built-in strong double-sided adhesive tape and does not melt under hot weather, no glue needed. The adhesive tape is designed to paste on the inside door edge, therefore it will not leave any residue on the outside door after the door trim is removed.
- Easy to Install: These door edge guards will protect your vehicle from nicks, chips & scratches.They install easily with no tools. They are U channel design and fit easily over any door edge, please ensure your door edge thickness prior to purchase.
- Advantages: Act as a car edge guard against nicks and dings, it look good.For your car offering a literal line of defense to keep the paint there looking as good as the day it was first applied and preserving the integrity of the metal beneath.